golden motor specs

No replies
1swiftturtle
1swiftturtle's picture
Offline
Joined: 03/05/2008
Points: 10

anyone provide me with the size of the circuit board in the 48 volt regenerative controllerand the low voltage out puts to power switchand to the brake cut off. i need to tap off 4 volts to supply small gps tracking device thanks guys 1 swift turtle

__________________

have been building e bikes and trikes for 6 years.personal ride is giant
chopper runing custom 36-72 volt crystalyte controller and combo 408-411
brushless motor.other bike is dynamic shaft drive with 408 front motor.
personal trike is industial 1000lb load singal speed with combo 408-411
and updated 36-72v controller,runing at 60v.halifax is very hilly and all
my bikes take me up with little or no pedalling. all e bikes use sla batteries
how ever will be updating with lithium soon.also sell and install solar and
wind,the latter since 1981.willpost results of subaru robin engine burning
ethanol on my other chopper.thanks 1 swift turtle

Electric Bicycle Conversion Kit Installation - Made Simple How to Design, Choose, Install and Use an e-Bike Kit
Revenge of the Electric Car The electric car is not only back from the dead, it's inevitable
JensonUSA Bicycle parts and accessories
V3 Cycle Analyst for Electric Bikes Ebike Display The Cycle Analyst V3 dashboard with speedometer sensor and magnet is a great addition to any Ebike
Simply Car-free How to Pedal Toward Financial Freedom and a Healthier Life



Who's new

  • baukienvn
  • palhymes
  • Major Dendrocopos
  • pavlom
  • ego75
Customize This