Regenerative brake

4 posts / 0 new
Last post
cferron
Offline
Last seen: 10 years 3 months ago
Joined: Tuesday, July 7, 2009 - 15:57
Points: 36
Regenerative brake

Is this a normal behaviour?

When I brake the generative break kicks in but no bars appear on the console until I reach a speed of about 14 km/h. It is only at that speed then you see the "G" bar until I come to a stop. As opposed to the G -4 Mode, even if I roll at a 30km/h speed and the mode kicks in, I see the bars on the console (from 30 to 0 km/h)

Normal?

Thanks

Claude

pondopholous
Offline
Last seen: 14 years 5 months ago
Joined: Friday, April 24, 2009 - 09:33
Points: 2
Re: Regenerative brake

I get one or two bars even when braking from a walking speed down to almost a stop. Mind you, I've boosted the regen braking effort setting to about 60 or so. If I remember correctly, the default brake effort setting is quite low.

cferron
Offline
Last seen: 10 years 3 months ago
Joined: Tuesday, July 7, 2009 - 15:57
Points: 36
Re: Regenerative brake

Low speed is not the issue in my case, I get almost ALL bars. When I brake at 32 or so I don't see any bars until I reach the 16km/h or so speed... My brake assist setting is setup to max power.

Thanks

Claude

Dennis
Dennis's picture
Offline
Last seen: 12 years 3 months ago
Joined: Monday, December 4, 2006 - 11:27
Points: 140
Re: Regenerative brake

When the regen is set to max, I hope everyone is checking their axle nuts before each ride.
a couple of helpful vids from FalconEV...

Log in or register to post comments

Buy Ecotric bikes, get free accessories!


Who's online

There are currently 0 users online.

Who's new

  • xovacharging
  • stuuno
  • marce002
  • Heiwarsot
  • headsupcorporation

Support V is for Voltage