Bmc 400w/600w 24v motor (USPD, lashout, Currie, Synergy cycles)

5 posts / 0 new
Last post
Pacific Ave Cycles
Pacific Ave Cycles's picture
Offline
Last seen: 13 years 6 months ago
Joined: Tuesday, March 2, 2010 - 00:31
Points: 7
Bmc 400w/600w 24v motor (USPD, lashout, Currie, Synergy cycles)

Does anyone have a use for any BMC motors with bad internal controllers??? i have about 25+ 400watt, & about 10+ 600watt... All motors cw d-shaft 24v 40a used mainly on Currie USPD, Synergy Cycles and Lashout Electric bikes. Motors will need a new external control wired in, These are the same motors as the Power Pack Motors were using, but they still have the internal controller sealed in.
Thanks
Daniel
Pacific Ave Cycles

tristanbe
Offline
Last seen: 13 years 11 months ago
Joined: Saturday, March 6, 2010 - 05:43
Points: 2
Re: Bmc 400w/600w 24v motor (USPD, lashout, Currie, Synergy ...

Hi Daniel, I could put one of the broken 600v BMC motors to good use. I think I bought my Currie bike kit from you guys a long time ago, and a BMC motor would make my recumbent go much quicker. What are you asking for it? Thanks

my4play
Offline
Last seen: 14 years 21 hours ago
Joined: Wednesday, April 22, 2009 - 05:51
Points: 1
Re: Bmc 400w/600w 24v motor (USPD, lashout, Currie, Synergy ...

I would be interested in a couple of them.. Please Email me and let me know if you still have some.
thanks
Karl

Pacific Ave Cycles
Pacific Ave Cycles's picture
Offline
Last seen: 13 years 6 months ago
Joined: Tuesday, March 2, 2010 - 00:31
Points: 7
Re: Bmc 400w/600w 24v motor (USPD, lashout, Currie, Synergy ...

Thanks for your interest... I still have them in stock. Bad motors are selling for $10 each, give me a call at 831-471-2453.

-Dan

friedwires
friedwires's picture
Offline
Last seen: 12 years 4 months ago
Joined: Friday, May 1, 2009 - 13:50
Points: 8
Re: Bmc 400w/600w 24v motor (USPD, lashout, Currie, Synergy ...

04131753.jpgthanks daniel, my two motors and controller showed up safe and sound today.you werent kidding when you said this would be a big project.i managed to get most of the potting out today,i could at least see all of the screws when i ran out of time.if anyone has any info on wiring an external controller,i would be grateful for your help

tattooed people are the same as everyone else except they are cooler and can kick your a@# !

Log in or register to post comments


Who's online

There are currently 0 users online.

Who's new

  • xovacharging
  • stuuno
  • marce002
  • Heiwarsot
  • headsupcorporation

Support V is for Voltage