Submitted by Fluid72 on Sun, 08/01/2010 - 13:14
Can someone inform me how to remove the rear swing arm?
Thanks
before comments
Submitted by danosj on Tue, 07/27/2010 - 11:59
Hi,
I bought a xtr lite 250 at a garage sale. The scooter was in pieces, controller board was removed, not batteries. I located batteries and re-attatched the c-board. I dont know how to connect the batteries to the controller board. Can anyone help?
Thanks, dano
before comments
Submitted by dtommyd on Fri, 07/23/2010 - 01:53
so I went to school today and a few miles later the bike cut out for about a second. My meter went yellow red and then back to green. 2 hours later on my way home it cut out after a 1/4 mile. I got home and pulled out the batteries and cut the wires to test each battery separately. The batteries seem fine. I was really hoping the soldering I did a year ago came loose. So - what do I test next? I need a scematic or a series of things to check. I've been riding for 3 years and it still runs good until today.
before comments
Submitted by Fluid72 on Thu, 07/22/2010 - 10:39
Does anyone know where I can get fenders for a schwinn electric scooter? I have a schwinn FX.
before comments
Submitted by medntee on Fri, 07/16/2010 - 10:32
hi
i have just bought a 36v 500w scooter and i love it
the problem is it has no power guage on it like a fuel guage
does any one know were i can get one that is simple to fit and will work like a range meter
hope that make sense
thanks
before comments
Submitted by Jason50153 on Wed, 07/07/2010 - 14:45
Hey all,
I am working on a project where I control two brushless motors for a scooter like device independently. These motors should be 100w or a little more, each. Also I want to be able to have the motors reversible in direction and have regenerative brakes. I know this is a lot of requests, but I really need help on this.
Is it even possible to do everything I have suggested? What specs should I look for in the motors? Is it possible to buy an esc for this?
Any answers to these questions or any other advice would be greatly appreciated. Thanks!
before comments
Submitted by Fluid72 on Wed, 06/30/2010 - 09:23
Anyone know if they make a free wheel sprocket for the 24v 900w motor? I have on for my 450w but it will not fit onto th 900w.
Thanks
before comments
Submitted by Fluid72 on Tue, 06/15/2010 - 09:13
Anyone know where I can get a 24v 900w motor for a schwinn missle?
before comments
Submitted by Fluid72 on Thu, 06/10/2010 - 09:32
My FS died and I was going to replace the motor but I am not sure what size motor is in there all ready, all stickers are gone. I am not even sure what size the controller is. Any suggestions for an upgrade?
Thanks!!!
before comments
Submitted by zip on Mon, 06/07/2010 - 16:18
Hi,
has anyone ever come across schematics for building 48V scooter controller?
tnx in advance.
before comments
Pages