Electra/Voy/Scoot 'n' Go Phantom 4

Submitted by arthurpage on Fri, 06/06/2008 - 18:32

Lighting:

head light, tail light, turn signals, and brake light

Number of wheels:

Batteries:

3 12volt 12 amphour

Controller:

36v

Conversion time and cost:

$190.00

Drivetrain:

hub motor

Location:

Portland, ME

Miles as an EV:

Motor:

500

Seating capacity:

Top speed:

Typical range:

10+

System Voltage:

25-36 volts

Vehicle maker:

ElectraVoy

Vehicle Type:

Light Scooter

Comments

Re: Electra/Voy/Scoot 'n' Go Phantom 4

Permalink Submitted by InTroubleAgain on Thu, 06/19/2008 - 20:04.

Just acquired one of these from craigslist, so my new PROJECT came fully ebquiped with rusty fasteners, cobwebs and dead insects (basement kept). I didn't even know what the thing was, since there were no markings, and had to "reverse engineer" the ID based on the battery! I got the thing, and an electric skateboard for $35.00 bucks, sans chargers. In other words, I now have a "PROJECT" (YIPEE!) to compliment the perfect storm of mid-life woes (lost job, 50, yada, yada, etc.) I gather the company that sold this thing went under, and parts sources may be limited, so my questions are as follows:
1. I found the owners manual on line, but there is little tech info. Is there a source for wiring diagrams, etc?
2. Can I replace the really dubious looking factory wiring harness with a "generic"? (i.e., make a new harness from say Radio Shack stock and connectors?)
3. Is there a comparable bike, made by an un-dead company that I can buy the parts for and swap into this bike?
4. Don't know that much about this technology, so keep it simple.
5. Charger, I need a charger!
6. Batteries: a good generic replacement recomendation.
Thanks, and god help me...