Electric vehicle controllers and control systems

I saw a controller on evparts.com
It's rated 100amp max 48-60v.
My question is does anyone think this could power an electric motorcycle? I've been looking at the alltrax 7234, but at $475 it may be out of my price range for this product.

Would I be wasting my time with the 100amp max controller?

Again thanks in advance to all you knowledgeable folks, Jazzy.

I have an Ez-go/Curtis 1206 non dcs controller.
I need a wiring diagram for a 0-5K pot.
It has a five pin interface.
Thanks Sean

Hi guys,

i have a controller from tnc scooters parts http://www.tncscooters.com/JC-116.php . i have some mistakes.i know my motor works as the battery.when i make the connections the fuse 30amp in the battery blows.ok when i try another connection i hear inside the motor some spin without movement.this is when i acelerate.ok when i perform others connections the motor dont run.what is the mistake?i try many different connections without succes.i have an electric cruiser 24v.thanks for the attention

has anyone ever or know how to wire this controller up i know it's labeled but if someone can edit the pic and show how the power and on/off ... it suppose to be a 24volt 80amp controller and that's pretty much all i know.. the part that i'm getting confused about is the extra tabs... thanks for any help :?

I need advice .

It is about digitally controlled fuel gauge.
You have TF bicycle, digital fuel guage chip + Battery M chip monted on battery pack , both chips have serial ports to communicate with host DSP processor. Fuel guage is dead, you want to replace it. After replacing , would host processor be able to communicate with replaced chip without running some kind of sofware? Simple would host be able to handshake with new chip which didn`t communicate with it before?
Any electronic guru out there?
Miroslaw

Does anyone know what type throttle the ego uses? the online manual says "HE" -- is this hall effect? how do I tell?
I ask because I just acquired an alltrax "AXE" to replace the stock, fire-damaged controller because of the programming features and to facilitate future mods.
if the throttle is hall effect, can I use it? I don't see that type listed in the manual. if I can't, what type should I use?

Now that my BladeZ has a Rad2Go motor and Curtis controller, I believe what I need to make it work is a new throttle. What do I need and where is a good place to get it? Magura 5 ohm twist? Thanks!
Old Buckeroo Bob

I have a schwinn scooter that currently has a BRUSHED motor. If I were to change it over to a BRUSHLESS motor would I need to change my throttle too or is the current one fine ?? Thanks for any info. God Bless :)

Someone posted a link on the old forms to a company that rebuilds Curtis/Alltrax controllers for very high performance cheaply. Anyone know the name of the company, or their website?