Hey guys, I recently transferred my PL350 to a new bike and now the auto-assist isn't working. The only thing I can think of is that I was using the motor with the wrong wheel size setting (20" vs. 700mm) and that messed something up, but I only rode it like this for about 5 min while I was testing out the new setup. Everything else seems to work normally--throttle, generative braking, etc.
When I put it into diagnostic mode (3772) the assistance values show 00 for all levels (1 - 4) while the generative values show 05, 10, 20, and 40. Also under these, a few other numbers/letters cycle through: 0033.7 (BAT appears right above the 7), Err, 25, and 1 47.
Is this as simple as turning on/off a control for auto assistance? Thanks.
Ok, looks like the problem might be the axle alignment as discussed here: http://visforvoltage.org/forum-topic/bicycles-and-pedelecs/1210-notch-bionx-axle