After successfully powering on the controller, it tells me (2,1). Which is throttle fault. I have the throttles hooked up correctly red-+5v out blue-TPS2 AN black-gnd. My question is if the throttle is not connected to TPS on the front of the controller, do I need to configure this in the software? I do not have the motor connected. Has anyone used Longma throttles?
Longma Throttle setup for a Kelly KD72301
Sun, 11/08/2009 - 21:45
#1
Longma Throttle setup for a Kelly KD72301
Who's online
There are currently 0 users online.
Who's new
- eric01
- Norberto
- sarim
- Edd
- OlaOst
Support V is for Voltage
