Flaky VX1 Tail Light

3 posts / 0 new
Log in or register to post comments
Last post
Wed, 01/02/2019 - 06:51
#1
MOSFETmeltdown
MOSFETmeltdown's picture
Offline
Last seen: 1 year 10 months ago
Joined: Monday, December 1, 2008 - 11:54
Points: 29
Flaky VX1 Tail Light

My tail & brake light is VERY dim.
What do I need to take off to remove the LED tail light?

Thanks in advance to responders!

Top
Sun, 01/13/2019 - 01:54
myvectrix2008
myvectrix2008's picture
Offline
Last seen: 3 years 6 months ago
Joined: Sunday, September 28, 2008 - 13:02
Points: 226
Re: Flaky VX1 Tail Light

Hi, if you still require this info, here's what the Service Manual states for VX-1 rear lamp housing removal.

Rear Lamp Housing Assembly Replacement

S-XC-S00173
THIS IS A CRITICAL COMPONENT. PLEASE FOLLOW RMA PROCEDURES AND REFER TO THE TECHNICAL SERVICE BULLETIN.
Removal Procedure
1. Remove the rear seat. Refer to Rear Seat Replacement in Seats.
2. Remove the rear cheek panel right. Refer to Rear Cheek Panel Right Replacement in Body Rear End.
3. Remove the rear cheek panel left. Refer to Rear Cheek Panel Left Replacement in Body Rear End.
4. Lift the lamp housing assembly off the scooter.
Notice: Do not drop or hang assembly from the rear wiring harness.
5. Unplug the wiring harness connectors from the tail lamp, both turn signals, and license plate lamp (1).

Top
Sun, 01/13/2019 - 04:00
(Reply to #2)
MOSFETmeltdown
MOSFETmeltdown's picture
Offline
Last seen: 1 year 10 months ago
Joined: Monday, December 1, 2008 - 11:54
Points: 29
Re: Flaky VX1 Tail Light

Thanks Steve,
I did still require this information, so this is much appreciated.
Regards Dave.

Top
Log in or register to post comments


Who's online

There are currently 0 users online.

Who's new

  • eric01
  • Norberto
  • sarim
  • Edd
  • OlaOst

Support V is for Voltage

Support V is for Voltage