Recently had the ESD charger fail on my Leaf converted VX-1. I was able to source a used Runke / EVSP. As my bike had Dugas Engineering's firmware, I uploaded the EVSP version of the software to the charger. I was relieved to see the bike charging again, and after monitoring two charge cycles that the firmware was working properly was happy.
However (and not sure if it was doing this from the beginning of the new charger install or it just started), when I power up the bike now I get the normal 'boot' cycle on the speedometer. The mileage of the bike comes on for a couple of seconds and then I get '63722' in the odometer window. Bike runs normally, I can cycle through to the odometer on the trip odometer gauge and see proper mileage. So, from an operational point of view I'm still good to go, but it's just bugging me!
Any ideas folks?
here is video showing issue
video
2015 Tesla S90D
2009 Vectrix VX-1 Leaf Conversion
1983 Lambretta Lynx
1980 Vespa P200
2013 VW Jetta Hybrid (gone....)
Link of video not working...
https://youtu.be/o2cjDQhl9XI
Link fixed. Sorry
2015 Tesla S90D
2009 Vectrix VX-1 Leaf Conversion
1983 Lambretta Lynx
1980 Vespa P200
2013 VW Jetta Hybrid (gone....)
I'll answer my own question - I need an activated version of XVectrix's firmware......
Thats the code that it shows.
2015 Tesla S90D
2009 Vectrix VX-1 Leaf Conversion
1983 Lambretta Lynx
1980 Vespa P200
2013 VW Jetta Hybrid (gone....)
The latest version doesn't need activation.
To my knowledge, the firmware now is free, but still needs activation. Better ask master Xvectrix
XVectrix has me all fixed up (thanks!)
2015 Tesla S90D
2009 Vectrix VX-1 Leaf Conversion
1983 Lambretta Lynx
1980 Vespa P200
2013 VW Jetta Hybrid (gone....)