Parting out my EVT 4000e

2 posts / 0 new
Last post
Jenn Rodriguez
Offline
Last seen: 13 years 6 months ago
Joined: Sunday, April 26, 2009 - 18:44
Points: 21
Parting out my EVT 4000e

I fried my motor and am parting out my beloved EVT 4000e because my job changed and, even with a new motor, I can no longer commute on it.

I have two chargers, two controllers, four B&B EB50-12 batteries (at least half-good by my estimate), tires (new and used), custom windshield, yellow trunk, rear rack, seat, yellow body parts, brake pads, etc.

Contact me if you need any used EVT parts!

Jenn
Santa Clara, CA
jennrod12 [at] gmail.com

adrian_nye
Offline
Last seen: 8 years 10 months ago
Joined: Tuesday, August 28, 2007 - 08:55
Points: 12
Re: Parting out my EVT 4000e

I would buy the shaft with magnets from your motor if they are intact. This could be
true if your wiring burnt out.

Have you taken the motor apart? Good instructions here:

http://www.7gen.com/book/my-ev-projects/cleaning-evt-hub-motor/701

The gear puller your can get for $12 at harbor freight. It helps
to duct tape it on while you use it.

Adrian Nye
Austin, TX

Log in or register to post comments


Who's online

There are currently 0 users online.

Who's new

  • Juli76
  • xovacharging
  • stuuno
  • marce002
  • Heiwarsot

Support V is for Voltage