Electric vehicle controllers and control systems
Log in to post new content in the forum.
| Topic / Topic starter | Replies |
Last post |
|
|---|---|---|---|
|
Help! scooter is reversing, and acting wierd at startup! Erider 4000watts by tdnevmo » Thu, 07/28/2011 - 06:03 |
0 |
by tdnevmo Thu, 07/28/2011 - 06:03 |
|
|
Has anyone bought this contoller? by zip » Sat, 07/02/2011 - 09:11 |
2 |
by zip Sun, 07/03/2011 - 04:02 |
|
|
Kelly KIM AC Induction Motor Controller, 24V-72V, 100A-500A by Kelly Controls LLC » Fri, 06/17/2011 - 03:18 |
0 |
by Kelly Controls LLC Fri, 06/17/2011 - 03:18 |
|
|
48V controller wire indentifiation by zip » Sat, 06/11/2011 - 06:20 |
2 |
by zip Sun, 06/12/2011 - 14:37 |
|
|
motor stop getting power after a few seconds by bionicjay » Sun, 06/05/2011 - 20:18 |
2 |
by mopedbrainy Mon, 06/06/2011 - 12:48 |
|
|
JC-116 Controller from TNC Scooters by pertneer » Fri, 05/20/2011 - 11:42 |
3 |
by pertneer Tue, 05/31/2011 - 12:09 |
|
|
DC/DC 3-phase drive needed by 37Dodge » Fri, 05/27/2011 - 11:12 |
4 |
by 37Dodge Sun, 05/29/2011 - 11:14 |
|
|
Bulk buy Ligoo BMS and charger from May14~May31 by lithium-manufacturer » Wed, 05/18/2011 - 01:29 |
5 |
by lithium-manufacturer Wed, 05/18/2011 - 01:41 |
|
|
Regenerative braking limits by GaryB » Mon, 05/02/2011 - 13:13 |
2 |
by strawhistle Mon, 05/02/2011 - 16:30 |
|
|
BMS and charger for sale by lithium-manufacturer » Tue, 04/19/2011 - 05:19 |
0 |
by lithium-manufacturer Tue, 04/19/2011 - 05:19 |
|
|
Boost converter 3.3v to 36V?? by colin9876 » Tue, 04/12/2011 - 14:55 |
6 |
by colin9876 Fri, 04/15/2011 - 23:26 |
|
|
Review: Lyen Edition 72V Controller by Zenid » Sun, 04/10/2011 - 20:08 |
0 |
by Zenid Sun, 04/10/2011 - 20:08 |
|
|
scooter wil not run by al7777 » Sat, 01/15/2011 - 11:17 |
11 |
by al7777 Sun, 03/20/2011 - 22:48 |
|
|
Using R/C brushless controller for bicycle hub motor (250W 36V 12A peak ~200RPM) by evaleto » Mon, 01/03/2011 - 01:32 |
2 |
by evaleto Mon, 01/03/2011 - 11:31 |
|
|
Which is the controller in Vectrix? by juan_75 » Sat, 12/11/2010 - 02:37 |
1 |
by marylandbob Sat, 12/11/2010 - 20:34 |
|
|
Need help with YK48-3 Wiring (Ignition/fwd/Rev) by BigAl » Sat, 12/04/2010 - 09:09 |
2 |
by BigAl Tue, 12/07/2010 - 12:26 |
|
|
Yet another way to fry controller! by jaustinmd » Sun, 06/28/2009 - 10:42 |
2 |
by BigAl Mon, 12/06/2010 - 07:55 |
|
|
hopping up a Panterra Freedom scooter by ruprek » Fri, 12/03/2010 - 02:35 |
0 |
by ruprek Fri, 12/03/2010 - 02:35 |
|
|
Curtis Controller 1205-205 36-48v 350 amp 0-5v throttle input. by ricoghardforth » Tue, 11/30/2010 - 14:27 |
4 |
by ricoghardforth Thu, 12/02/2010 - 03:29 |
|
|
Adding a Battery in Series Between the Controller and Motor by e-doggies » Thu, 11/18/2010 - 21:21 |
9 |
by 7circle Sun, 11/21/2010 - 18:44 |
|
|
new electric board build, need help with using an rc car throttle controller. by electric board1 » Tue, 11/16/2010 - 10:21 |
0 |
by electric board1 Tue, 11/16/2010 - 10:21 |
|
|
scooterteq controller is bad. none available. Any ideas by fatto » Sat, 07/17/2010 - 17:47 |
9 |
by Truspex Sat, 10/23/2010 - 08:03 |
|
|
Can anyone identify this controller? by bionicjay » Thu, 05/28/2009 - 18:22 |
2 |
by RFA Fri, 10/15/2010 - 05:44 |
|
|
e-crazyman fault - help! :( by Zenid » Sat, 10/09/2010 - 03:49 |
0 |
by Zenid Sat, 10/09/2010 - 03:49 |
|
|
Reverse on an electric motor by chizzer » Tue, 11/18/2008 - 09:13 |
17 |
by Alex77 Thu, 09/30/2010 - 03:56 |
Log in to post new content in the forum.
Who's online
There are currently 0 users online.
Who's new
- eric01
- Norberto
- sarim
- Edd
- OlaOst
Support V is for Voltage
